What should be paid attention to in the daily maintenance of multifunctional brick machines?

In the production of concrete products, multifunctional brick machines are commonly used equipment. The operation is not difficult, and brick factory workers can operate them after proper training. When there is a problem with the operation of the block equipment, skilled operators can immediately determine where the problem is caused, and the operators can repair and maintain it by themselves. In order to prevent the brick making machine from malfunctioning and stopping production, it is necessary to pay attention to daily maintenance when the machine is shut down after work. So pay attention to the following points:

1. Do a good job of daily cleaning of the multifunctional brick machine. The operation of the block forming machine is to pressurize and vibrate powdered cement or other raw materials into blocks, so it is often polluted by cement dust. When cement dust enters the main transmission and heat dissipation components in the block equipment, it will cause the machine to operate abnormally. For these key block components, the accumulation of dust is also a potential safety hazard. Therefore, it is necessary for the brick factory to designate operators to regularly clean and maintain the new brick making machine, disassemble the parts that need maintenance, and then wipe them with mechanical maintenance supplies. Dead corners can be cleaned with a soft brush.

2. After the multifunctional brick machine has been in production for a certain period of time, the performance of all aspects of the equipment will be somewhat reduced. When encountering such a problem, the brick factory needs to take appropriate measures to restore and improve the performance of the brick making equipment. This requires adjusting the running speed of the block equipment. After the machine has been running in a fixed gear for a long time, the transmission efficiency has decreased and the speed has slowed down. The equipment operator of the brick making factory should appropriately adjust the speed of the equipment to speed up, so as to ensure that the operating performance of the mechanical equipment is improved.

3. The maintenance personnel of the brick factory regularly add lubricating oil to the multifunctional brick machine. After some sliders and gears have been used for a long time, the lubricating oil on the equipment will slowly be consumed. This will reduce the operating efficiency of the machinery and equipment, and without proper maintenance, the operating speed will not meet the parameter standards in the end. In order to increase the speed, the maintenance personnel should apply some lubricating oil to the sliders and gears of the brick machine production line to reduce the transmission friction resistance.

4. The new brick making machine equipment should be placed in a dry and cool place. After all, it is a mechanical metal product. If it is placed in a brick making site with high air humidity, it will create an environment for the equipment accessories to rust. In order to prevent the machine from rusting and corroding, it should be placed in a cool and dry place when it is not often used.

If the multifunctional brick machine can be properly repaired and maintained, it can ensure the daily production volume and normal service life requirements of the brick factory. Moreover, correct daily maintenance can also reduce the probability of mechanical failure. This is also a hidden danger prevention measure for manufacturers. It avoids the maintenance of many mechanical failures and reduces the maintenance cost of the brick machine.